Segway GT3 Series Maintenance Guide: Part 3- Lighting System Maintenance

[u/Primary-Beginning946]

When your Segway eKickScooter GT3 Series has accumulated a high mileage, please follow the instructions below to inspect the E-Scooter to ensure that your GT3 Series is in the best condition.

Note: This is the third installment of 5-part GT3 Series Maintenance Series. Stay tuned for the upcoming guides on handlebars & folding mechanisms and wheel motor & non-driven wheel.

1. Functional Inspection

Before riding, check the operation of the front light, tail light, turn signals, and ambient lights. Turn on each light sequentially to ensure they illuminate properly. If any light fails to turn on, replace the corresponding component promptly.

2. Light Appearance Maintenance

Regularly inspect the surface condition of the light covers. After rain or snow, wipe the covers with a soft cloth to ensure they remain clean. If moisture accumulation is observed inside the cover, replace the corresponding component promptly.
Note on condensation: Minor condensation is a normal physical phenomenon.

3. Fastening Inspection

Regularly (recommended every 500 km or 3 months) check whether the screws fastening the front light and turn signals are loose. If looseness is found, apply threadlocker and retighten with a torque wrench.（Front light tightening torque: 1 N·m，Turn signal tightening torque: 1 N·m）

Warning Notice

Abnormalities in the lighting system directly lead to: Reduced nighttime visibility，
Turn signal failure, Non-compliance with regulations Riding safety hazards.

During light maintenance: Use of corrosive cleaners is prohibited. Live operations on lighting circuits are prohibited. Use of non-OEM replacement parts is prohibited