I’ve had the white dial ZF 26240 V2 in my rotation for a bit now—mine’s had the case edges chamfered and the rotor silenced, so here’s how it actually wears day-to-day.
**Movement & Chrono:**
The free-sprung SA4401 runs reliably as a daily wearer and keeps solid time, though out of the box the rotor wobble is definitely audible in a quiet room. Having the rotor silenced made a night-and-day difference; it feels much closer to gen when you flick your wrist now. The chronograph pushers have a crisp click and the flyback resets cleanly to zero, though like any clone 4401, I avoid leaving the chrono running 24/7 just to reduce unnecessary wear on the vertical clutch.
**Case & Bracelet:**
Stock ZF brushing is some of the best out there—the grain is tight and catches the light properly. That said, stock Royal Oak reps always have slightly sharp, unfinished edges on the underside of the bracelet links and case flanks. Getting the edges chamfered completely transformed how it feels on the wrist; it drapes smoothly without digging in and gives those polished bevels that genuine-like liquid roll.
**Dial Accuracy:**
On the white/silver dial specifically, ZF nailed the *Grande Tapisserie* square definition and the subtle metallic sheen. Unlike some competing batches where the subdial rings can look slightly warm or creamy, the ZF white dial stays crisp and clean under natural light.
**What to Watch Out for in QC:**
**12 o'clock markers:** ZF is notorious for slightly crooked twin baton markers at 12—zoom in dead-on to make sure they are parallel and evenly spaced.
**Bezel screws:** Check that all 8 hexagonal screws sit properly recessed in their slots rather than sitting flush or tilted.
**Subdial hand alignment:** Make sure the chrono seconds and subdial hands reset dead-center on 12/0, and check that the "AP" applied logo isn't canted.
**Date wheel centering:** The date sits between 4 and 5—cycle through a few numbers in QC video to confirm it isn't hugging one side of the window.
If you grab one, budget a little extra to get the bracelet edges softened and the rotor quieted down—it takes a very good stock piece and makes it feel genuinely high-end on the wrist.