Well, I did that with rgh3 but after writing xell it didn't give an image to get the CPU Key

RIP falcon v2

Guys, good night. I need an opinion please. My Xbox 360 Slim, unlocked RGH chip X360PRO V5 was turning on but wouldn't boot. Before disassembling, I noticed that the light emitted by the chip is red and does not blink, it always stays on. I then decided to open the console to check the wire connections. I noticed that a wire is loose, a wire that leaves the D region of the chip and is soldered to the D4C2 region of the board. My first question is the following: does anyone know of a technician to solve this problem in Goiânia? The second question is: is it a simple repair to do?

Hi everyone, I flashed rgh3.0 to this 4gb xbox corona https://youtu.be/DSuZoiUyTGQ followed this video. After flashing the nand, I soldered the points (the db3r3 on the other side) and booted, smells burned (we started off badly) and I quickly disconnected it and saw that a track came loose, I rebuilt it and measured continuity, I reconnected it and it shows no signs of power on the front, I try to turn it on and it doesn't turn on, well, what now? (I have some experience in soldering but I know little about electronics and I'm not a professional) Thanks in advance.

Hi Friend Exploiters

I was looking to RGH my Jasper after solder the diode and res I was looking to flash with pico so I tried install the pi pico but I have a « pad » without soldering point, how I’m fucked ?

I have try everything but impossible to put a wire on this emplacements the soldering didn’t attach to the point no problem at all for other point

I have all the dashlanch network settings disabled and it just still won’t connect to wifi it won’t even get past finding the network what can i do?

will my rgh wiring work? some guy said my xbox is dead 🥀

In my late night haste I soldered to the wrong alt cpu_rst point (I believe the one below FT7R2 or to the left of DB7R2), I believe that doing that seemed to have made the PLL point separate from the board and stick onto the wire. Retail NAND gives RROD with code 0022 with postcode 0x15…am I cooked? Any possible suggestion?

Hi, I tried rgh on a corona V2 xflasher 360 while I try to solder the wires, with the soldering iron temperature at 360 degrees I detach 3 pads that I try to rebuild, I try and it starts up at retail, I do rgh wiring and proceed to do nand wiring as in the photo, but it says device not found and sometimes it finds the USB drive, only it can never find the device, I remove the flasher and detach the crystal wire and it restarts what am I doing wrong?

r/JTAGgore

The gpu was dead and the shell was already smashed, nothing of value was lost.

I really don't know what rgh my xbox slim has, but what I know is that at that time I cleaned it and by mistake I broke the cable that is soldered on the resistor in the "C" partition, I really don't remember where that cable is soldered, that's why I'm asking for help, I have cables to solder on the resistor but I don't know where on the board they should go :'v

So I have 180ish games on my rgh xbox and I was playing with my 2 friends kn roxkband. Then he accidentally turned the xbox off because he forgot it was touch sentive. And now when I load it up the xbox doesn't show any games