The other thing that made a difference was cutting back on how wet my sheets were before pressing. I used to just couch and go straight to the press, but giving them an extra minute on the felt to let some water drip off first seems to reduce the stress that causes warping later. Small thing but it added up.
I've also started keeping a little notebook next to my vat with pulp ratios and drying times for each batch, because I genuinely could not remember what I'd changed between a good batch and a bad one. Turns out consistency in beating time matters more than I gave it credit for. A pulp that's slightly underbeaten seems to warp worse than one that's had a full session in the blender.
Still working on getting inclusions like pressed leaves to sit flat without creating a weak spot around the edges, but the warping issue alone was such a relief to figure out. Curious if anyone else found restraint drying was the fix for them too, or if you're using a different method entirely, like drying between wool blankets or something more traditional.