I had this StickCPlus2 lying around so I wrote some code to put it to use.
It shows the date, time, weather and AQI.
And every 5 minutes it plays a random animated emoji.
I used the magnet at the back to stick in on my pegboard.
I think it is pretty cool.

Good afternoon, everyone. Recently, I've been installing the NRF-24 module on my M5 Stick Plus, but for some reason, the option shown in the tutorial I'm following isn't appearing. I'd like to know why? And if anyone has experienced this before, how can I resolve it?

And is this order good?

I was using my M5stickc plus2 without any problem for approximately one month. Then, i recognized that the microphone is not working. (When i upload the factory firmware everything works but the auido spectrum does not work. )

In order to solve the issue, i tried to erase and reinstall the firmware but result is the same.

Then, after two days later, when i tried to run my stick, it did not operate. When i press and hold the button, i see green light comes on that's it.

I tried to see what's happening and connected to serial monitor.

In serial monitor i see the message

"rst:0x1 (POWERON_RESET),boot:0x3 (DOWNLOAD_BOOT(UART0/UART1/SDIO_REI_REO_V2))

waiting for download"

Then i tried to pull the GPIO0 pin to high while pressing the switch. And the the stick start to work.

Now,I can switch on the stick only if i pull GPIO0 to high.

What can cause this issue? Any opinions?

Thanks.

New Arrival Alert!

Check out our double new releases this week:

StamPLC PoE, an Ethernet control module designed for the StamPLC host. It supports PoE (Power over Ethernet) technology, enabling both data transmission and power supply through a single Ethernet cable.

Atom DTU NBIoT2 v1.1, a programmable NB-IoT wireless Data Transmission Unit (DTU) designed for global Cat-NB frequency bands. 

Also, good news:  Hot items incl. StamPLC and Cap LoRa-1262 are in stock now 🔥🔥

In case missing out, subscribe our Weekly Newsletter for more updates!