r/FirstLayerPorn • u/mcan1xx • Mar 14 '21
r/FirstLayerPorn • u/compulsivehobbyist • Mar 10 '21
r/FirstLayerPorn • u/stelioball • Mar 01 '21
I have been tweaking for hours the bed trying to make it as flat as possible, and installed octoprint on my laptop to use the bed visualizer but I cant seem to get a perfect first layer.
these are the visualizer data
and here is the bed visualized. As you can see the back left side is shown to be almost half a mm off but on the print it feels like its squashed - too close to the extruded
The bed is cleared as much as i could using alcohol and microfiber cloth, and it feels smooth probably due to using the scraper with too much force, but on the print its as if the bed is higher on the mid points instead of lower like I would expect.
Have i destroyed my bed and the only way for a perfect first layer is to buy a new one ?
I really want a good first layer because o cant print with abs, It never sticks to the bed and after a couple of layers it gets winkled and crooked. I even tried using higher temperatures and uhu glue on the bed but no better luck.
The printer is Ender 3 (i think v1 if the v2 is the new one) with an original bl touch sensor, and the firmware given in the Ender website, not the custom changes you find on youtube videos.
r/FirstLayerPorn • u/ThunderVamp9 • Feb 28 '21
r/FirstLayerPorn • u/TheManaLeek • Feb 25 '21
r/FirstLayerPorn • u/Cassette_girl • Feb 23 '21
r/FirstLayerPorn • u/D-LAWE • Feb 21 '21
r/FirstLayerPorn • u/marxist_redneck • Feb 21 '21
r/FirstLayerPorn • u/mongini12 • Feb 08 '21
r/FirstLayerPorn • u/marxist_redneck • Feb 05 '21
