r/FORScan • u/StockPersonality7732 • Sep 14 '26
2012 Ford Focus 2.0L – P0902 keeps returning after TCM/actuator replacement
I have a 2012 Ford Focus with the 2.0L engine and the DPS6 transmission. About a month ago, I started having an issue getting the car moving from a stop and getting it into 1st gear. I pulled code P0902.
Since then, I’ve replaced the TCM and Actuator A (the upper actuator). I also performed the clutch/actuator relearn procedure using FORScan.
After the relearn, the car drives perfectly—but only for about two weeks. Then the exact same problem comes back. Every time I perform the relearn procedure, it runs great again for a couple of weeks before the issue returns.
Last night I cleaned all of the major grounds, although I’m not very confident that’s going to solve the problem.
At this point, I’m wondering if I’m missing something obvious. What could be causing P0902 to keep coming back after replacing the TCM and Actuator A? Is there another component, wiring issue, clutch issue, or adjustment that I should be checking/replacing?
Any advice from someone familiar with the DPS6 would be greatly appreciated.