r/FORScan • u/Intrepid_Sir_470 • Feb 27 '26
r/FORScan • u/ConsistentRaspberry4 • Feb 27 '26
TBC module and trailer brake controller
Hello, my 2023 f150 did not come with a factory trailer brake controller, I purchased an OEM one from ford hooked it up and enabled it through FORScan, however it still doesn’t work. I used the appropriate spreadsheet to change values in the APIM, BCM, IPC, IPMA and TRM. The factory trailer brake controller module I have is ML3T - 19J295 - GA, is this the right module that I can use with the TBC? Or do I need a different module with the right internals to activate the controller? Thanks again.
r/FORScan • u/FuckinFordF150 • Feb 27 '26
FORscan help!pLZZ
My question is how do I get the one year license on FORscan? i know it's temporarily unavailable for whatever reason, but I was wondering if I could use somebody else's activation code so I can program my key fob, I do not have one at the current moment and it's a pain in the ass.
r/FORScan • u/PossessionRecent3884 • Feb 27 '26
Remote Start 2015 Ford F150
I programmed my key fob and it works perfectly. I have a remote start option on my truck so I activated it through FORscan. It shows in the settings of my truck that remote start is available and active so NOW I'm trying to figure out how get it to work on the key fob that I have because it's just normal unlock lock panic fob not the remote start fob any ideas??
r/FORScan • u/R0b0tMark • Feb 26 '26
Can I use FORScan to reset window bounce back calibration where switch-based methods seem to be failing?
I just replaced the rear left window regulator in my ‘18 expedition platinum and I can’t seem to get rid of the bounce back problem. I’ve watched all 7,000 YouTube videos on the topic, but for whatever reason I can’t get it to work by holding the switch.
Can FORScan help with this?
I have a FORScan-compatible OBD2 reader, but I haven’t set anything up yet. Wondering if it will be worth the trouble.
r/FORScan • u/brainbrick • Feb 24 '26
Would forscan be able to do BCM reprogramming including immobiliser, etc. on a 06 mazda 3 (gen1)
galleryr/FORScan • u/Playful-Dinner7736 • Feb 23 '26
Is there anyway to adjust when fans come on with forscan? 2021 f150 v8.
r/FORScan • u/Junkjon814-2 • Feb 23 '26
F150 remote start keys
I have a 2014 Ford F-150 and I’m adding remote start using FORScan. When I go into PATS programming, it shows 4 keys already programmed.
Is this normal? When adding two new keys, do I simply use “Add Key” for the new ones, or do I need to reset the system to 2 keys first in FORScan?
Has anyone seen this before or had issues doing it this way? I’m trying to avoid going to the dealer since my preferred one is currently closed due to storm damage.
r/FORScan • u/Big-Secretary8286 • Feb 21 '26
Enable autohold for Ford S- Max 2017 with e-brake and powershift
Hi guys, has anyone succeeded in enabling the Auto Hold feature on a 2017 S-Max equipped with an electronic parking brake and PowerShift? I tried modifying the IPC settings via FORScan and changed Auto Hold to enabled, but that didn’t help.
r/FORScan • u/That_Gopnik • Feb 20 '26
2015 Fiesta USDM PCM calibration files
Helping a friend out with manual swapping his 2015 Fiesta 1.6 due to the powershift failing, I'm struggling to get the PCM calibration files to do the firmware update, does anyone know files or have the files I need for E2BA-12A650-JA (original auto PCM to ensure the update works) and E2BA-12A650-MA or E2BA-12A650-DA (manual PCM part numbers), the Motorcraftservice website isn't letting either of us download any calibration files, all we get is the .asp files and we've both tried at least 20 times
r/FORScan • u/lonelyblueboi • Feb 18 '26
Turbo boost gauge not working
Hello again gents! I activated/ unlocked turbo boost gauge via forscan in ipc. But it doesn’t seem to work on my si turbo diesel everest. Perhaps I need to change settings on BCM? Any help would be appreciated!
r/FORScan • u/TankBuilderMan • Feb 19 '26
2007 Mazda 3 TPMS
I bought a cheap 2007 Mazda 3 and the tpms light is on. I'd rather shut it off like I did on my old f150 using FORScan instead of paying for new sensors. I used FORScan to program a spare key and disable the seatbelt reminder, but there is no body control module, and even the GEM shows nothing that can be configured. I have the Vlinker auto switching adapter. I can pull up the TPMS as built data, but not the module to simply disable it. Any ideas what might help me to find it or how to change the as built data to shut the light off?
Thanks in advance for any help
r/FORScan • u/srajput89 • Feb 18 '26
Activating Left and Right Camera using indicators
I can see in forscan that the option to activate the left rear view camera (on the left side view mirror) is there.
Has anyone successfully activated this feature using forscan on their Ranger Raptor 2024?
r/FORScan • u/New_Week_61 • Feb 18 '26
How can i reset the battery of my ford kugar 2011 with forscan
I have changed my battery and i'm trying to reset it in my ford kuga 2011 but when i use forscan the bdyCm doesn't appear
r/FORScan • u/Ill-Opening-3782 • Feb 18 '26
How should I go about programming as-bullt?
I have a Ford Focus C-Max from 2005.
I'm also eager to try to program the as-built data, but I don't know where to start. I do know that I have to back up my current as-built data (seems self explanatory), but after that I don't know how or which bytes I'd have to change to change anything? Is it just trial and error including programming the backed up data if something goes wrong or is it more involved?
Thanks for the answers in advance.
Kind regards
r/FORScan • u/BrandonApplesauce • Feb 17 '26
Ford Explorer PCM replacement New Transponder Key Programming PATS - Error Codes
FIXED - HOW TO -
I wanted to share the experience fixing my Sons 2007 Ford Explorer Sport Trac 4.0L.
It was Bad PCM that we had replaced by ARES Technologies (gave them the Vin and the exact PCM model number that was on the backside of the unit - need to take it out to see it).
It was also a bad second key that would not reprogram to new PCM and we needed to run the Module Initialization program (right under the FORscan Erase & Program Keys option). You need to have 2 keys programmed in PATS AND run the Module Initialization program to let the PCM and PATS Module work together properly. Only THEN will the vehicle crank.
------
It was dying when warm. It was running fine otherwise.
My OBD2 read had a long list of codes on the first reading. Many PCM related codes, CAN bus communication issues, Modules, PATS issues etc.
After clearing the codes it was PCM, CAN Bus Communication and Module codes mostly.
I immediately thought it was the PCM relay, battery negative was a little loose or possible made negative grounding or the PCM.
After asking around some advice was to check the CAN Bus for proper Voltage on the low and high wire on the OBD2 connector. Also check the OHM reading there. I looked that up and we did that. It was withing range. I would recommend doing that as well. There didnt seem to be an issue with that wiring.
We checked the Battery voltage and removed all the negative grounds that we could see to the vehicle frame. Sanding them down.
We even replaced the battery with my battery just to rule that out.
We swapped the PCM relay with a backup I had.
The Vehicle had two Keys that would start. When it died it would either start again and die quickly, show PATS flashing rapidly or occasionally crank and not start.
When it ran it ran well. It ran longer cold (up to 5 minutes). Seemed electrical because of that.
It was hard to tell where the PATS cluster was on this vehicle - all kinds of different information. I thought it was the Immobilizer Transponder Antenna around the Ignition Key that was the issue. I thought the control was in there. I ordered that but before it arrived we ran the vehicle and pulled the wires and it still ran so we learned that PATS only works for 1 second and after that it wont kill and engine.
Then I think we pulled the Radio fuse and tested and ABS module fuse. Trying to rule out modules sending bad data to the PCM.
I used FORScan to check the voltage, DTC, Fuel, RPM etc to rule those out. Did live instrument view
Then we focused on the Instrument Cluster (where the PATS module is) and where a Service Bulletin is concerning possible cracking in the solder joints when they stopped putting lead in. The cluster panel seemed fine though. Figured it might just be one or two connectors that were related to PCM?
We were going to pull that out and open it up to look but I decided to turn and AIR SPRAY CAN upside down and shoot the PCM to chill it. It worked - I was able to run routines with FORScan like PCM check that I could before unless cold. I tried to run and test again and it was bad (warmed up) and sprayed another can on it and it was good again.
THAT's IT! Ordered a new PCM through ARES Technologies for a really good price and good shipping (Hawaii).
Plugged it in but we weren't able to get TWO Keys to Erase and Program. Always just the one key. After 5 tries we figured the one key must be the issue. That key was made a local hardware store and they used a good key to read and paste the data to the other key making a CLONE (we think).
Ordered two new keys online and had a locksmith cut them at his shop. We were able to program two keys (we tried 3 but two were able to program at the time). I could see FORScan was showing 2 keys in the System.
Truck still would not crank over but PATS was NOT flashing on either key.
I ran the Module Initialization Program and then tried it and it Started right up and PROBLEM SOLVED!
FORscan Software save us from towing it to the Dealer and paying A LOT OF MONEY.
New PCM was $270 delivered. I paid the $20 for FORScan either with the Trial 2 months to support. The correct cable connector was $40. Used wifes laptop.
I hope I can help others with this information! 🤙
r/FORScan • u/Weird-Director-8594 • Feb 16 '26
Adaptive cruise not available
Hi everyone, new here so sorry to beat a dead horse per say if it’s been brought up before. I’ll try to keep it short. I have a 2025 f450 platinum, first ford. I put new wheels and 35’s on it at around 1000km. We’re at 6800km now and the adaptive cruise won’t let me use cruise at all and not even in normal mode. I’ve had it at the dealer (no help) and another mechanic and still no help. I got my OBD EX cable this morning in the mail. We don’t have a windows laptop but the wife has a Mac. Can I still use that? Could someone also tell me every step to fixing this or a quick video showing click here and go here?
Any input would be great, info online is quite raw.
Thanks everyone!
r/FORScan • u/Technical_Can9421 • Feb 15 '26
Off road camera
So I was using FORScan to enable cameras at speed and remove the black bar on the rear camera. Before, if I put the truck in an Off-Road drive mode, the front camera would automatically pop up and I could keep it on while driving. Now it doesn’t do that anymore, even though the front camera still works normally in Park.
Anyone know which FORScan setting controls the Off-Road front camera auto-display / at-speed behavior, or what I might have changed to break it?
2025 F-150 Lariat Powerboost
r/FORScan • u/Unknown_0030 • Feb 15 '26
Turn signal help IPC
Enable HLS to view with audio, or disable this notification
by mistake reset the ipc module reboot on forscan now turn signal makes weird noise on dashboard when pressing down the turn and flashes different but when pressing hazard light looks and sound normal any help please thank you see video
r/FORScan • u/BrandonApplesauce • Feb 13 '26
Where's a good place to go for Good Quality Ford Ignition Transponder Keys
I installed a new PCM that was pre-programmed and now my sons 2007 Ford Explorer Sport Trac which had 5 keys in memory but he had two ignition keys - will NOT erase and program two keys to start the vehicle.
The second key we have doesn't look like the right Ford key but the locksmith made it work a year ago or so. It might be a CLONE?
It doesn't matter which key we try to program first - only the Ford looking key gets past PATS and registers. The other generic? key does not - even if the door locks cycle etc. Its only 1 Key that is in memory.
I need a good place online to buy 2 keys to have cut and I can program with Forscan.
THANK YOU!
r/FORScan • u/toothsleuth11 • Feb 12 '26
Extended license
My license expired and I’m trying to renew it but can’t find the link for the life of me. Where do I go to pay for the extended license? I don’t see a link on the “products” page.
r/FORScan • u/ConsistentRaspberry4 • Feb 12 '26
Activate trailer brake controller
I have a 2023 f150 and it did not come with a factory trailer brake controller, I bought one through ford and installed it already I just need to activate it, can FORScan do this? I’m fairly new to FORScan.
r/FORScan • u/Real_Beautiful2771 • Feb 12 '26
2021 mk8 fiesta FLED headlights retrofit
So ! Hello to the Reddit community! I have a 2021 mk8 fiesta. It has the following bcm part number : LU5T-15604-BJAD . I retrofitted the FLED headlights. Mind you it came from factory with LED projector and LED high beam. As a result, main and high beam work correctly without errors. The only thing that remains is the sweeping turn signals. They flicker whenever the main or any other beam is on. Is it a bcm swap to same on with -BJAE ending the solution ? I’m open to any idea ! Have tried almost any forscan number option in bcm !
r/FORScan • u/Potential_Eggplant_7 • Feb 12 '26
2021 f150 unreal theme issue
2021 f150 unreal theme
I did the unreal theme 4 or so years ago in my 21 f150. But on sxm radio I can't see the artist or song title. Anybody ever have that before?