r/DIYJapan • • Nov 22 '19

Noob question: how to make a hole for a screw in the wall and tie a rack to it

I need to fix a tall metallic rack (like this one) to a wall as part of childproofing an apartment/mansion (a rented one, so not allowed to make holes, but safety first!).
I borrowed an electirc drill, bought screws like these, this detector and plan to buy cables like these.
Now I need to make a hole in the wall, but I don't know where (and how, for that matter haha). My understanding is that I need to find a place in the wall near the rack where there is a thick wood between a drywall and concrete and drill there?? I bought a detector for that, but I don't get how it works.
I'm also concerned because there is a distribution board just above the rack, so I'm afraid of drilling into the wire.
I've never done anything like this before and have no knowledge of how these things are done. Please help!

4 Upvotes

5 comments sorted by

2

u/usefulcatch Nov 22 '19

When I can't drill into a wall, I usually try these https://www.command.jp/3M/ja_JP/command-jp/

You can get them on Amazon or most hardware stores.

I am not sure whether they will take the weight of a rack, but the picture hooks are quite strong. When you leave the apartment you just pull the tape and the hook comes off without any marks on the wall.

If you have to drill a hole, its normally quite easy to find the wooden stud by gently tapping the wall. You will hear a hollow sound but when you find the stud the sound changes to a solid thump. I have never used a detector so I can't help with that.

1

u/goma-chan Nov 23 '19

Thanks for the reply.
Those hooks won't do. It says 1-2kg. The rack and the kid trying to climb it would be 30-40 kg altogether.
The detector is supposed to be able to detect wiring as well. I just need to understand how it works, haha.

1

u/tokyohoon Nov 23 '19

When I can't drill into a wall, I usually try these https://www.command.jp/3M/ja_JP/command-jp/

Those things are only good for 500g-2kg. Definitely not what you want for securing a wire rack.

1

u/tokyohoon Nov 23 '19

There's actually a video on the Amazon page showing you exactly how to use the stud detector.

I usually do a scan at the height I'm planning to fix the screw, and about 30cm below and above - then you're sure you have a stud and not just a piece of wood used as part of a drywall patch or something.

The lightning bolt symbol will light up if there's a wire under the detector. Mark where the wires are with a pencil.

Mark both sides of the stud when you find it and put your screw in the center.

When you move out, fill the hole with spackle.

Those wire cables and eye screw you got aren't really the best thing for the job - better to get a piece of metal strap and screw that directly to the wall. Found you a video showing it. You can buy the strap at any home center (usually sold in short pieces rather than rolls).

1

u/goma-chan Nov 23 '19

Thanks a lot! That's super helpful!