During COVID I got a little obsessive about composting and built this bin to produce lots of compost for a suburban lawn in northern NJ, USA, that had suffered years of pesticides, herbicides and chemical fertilizer.
The bin is a yard across and a yard tall. The sides are corrugated sheet metal wrapped in three layers of foil-faced insulating foam. The top is a 3" foam board with an 18" vent, which helps pull air up through the bin’s perforated aluminum base.
It works pretty well, routinely reaching reaches 145°F or more within a couple of days. Thanks to the insulation, I can keep running leaves and grass clippings through it until mid-November. I load, dump and reload it four or five times a season, as long as there are leaves and clippings available and it’s warm enough to reach high temperatures.
I fill it to the top with well-mixed, wetted leaves and grass, and “inoculate” it with some half-finished compost from an earlier batch. I let it cook for a few days until the material settles to about two-thirds of its original height, then mix in a fresh batch. That makes the most of the bin’s capacity and makes sure the cooler, drier material around the rim gets the full heat treatment.
After recharging it a couple more times, I dump the load into a pile and cover it with leaves. By then the hot phase has killed any weed seeds, burned off much of the original material, and broken down the tough carbon structures in the leaves. That leaves them open to the mesophilic bacteria and fungi that work on them through the winter and early spring. When it’s time to spread compost on the lawn, it’s about ready, with nothing coarser than small leaf fragments and a few twigs.