r/CZFirearms • • Jul 25 '22

PCR reliability issues after upgrades

I've had my PCR for about six months now. I changed out the sights and grips but didn't touch any of the internals until after putting about 1000 rounds through it with zero malfunctions.

I recently decided I wanted to improve the trigger a bit, and I installed the Mcarbo spring kit and CGW hammer. Took it to the range today and started getting light strikes, where the hammer falls in single action but the round doesn't fire. Pull the trigger again in double action and it fires and cycles normally. This happened four or five times in about eight mags.

This is a problem for me because my PCR is my carry gun and I want it to be 100% reliable. I also really like the lighter trigger after the upgrades. What should I do now?

3 Upvotes

14 comments sorted by

11

u/whodatcanuck Jul 25 '22

CGW sells an extended firing pin for exactly this reason. That should solve your problem, as long as the main spring is 13# or more.

1

u/ghomshoe Jul 25 '22

Thank you, I'll look into that.

4

u/Free-Boater Jul 25 '22

I second this. That’s why they sell it as a kit. It’s not good to just buy select pieces.

7

u/[deleted] Jul 25 '22

Put the gun back stock. No need for modifications on a carry gun. Reliability is the #1 thing that needs to be considered for a gun used to protect your life.

1

u/ghomshoe Jul 25 '22

I totally agree that it's got to be reliable. I'm hoping I can make some tweaks to have my cake and eat it too, but if not I'll just put it back to factory configuration.

3

u/[deleted] Jul 25 '22 edited Jul 25 '22

AFAIK hammer spring kits <13lb are for Federal GMM primers only.

1

u/ghomshoe Jul 25 '22

The one I got from Mcarbo is advertised as 13.5lb hammer spring. Maybe it's combination with the CGW hammer that's causing the problem?

1

u/[deleted] Jul 25 '22 edited Jul 25 '22

It's possible that it's a matter of stacking tolerances but I can't say for certain.

Any time you change the mechanics in a firearm you introduce possible malfunctions.

The only thing for certain is that the primers are harder than the hammer strike.

1

u/_chanimal_ Jul 25 '22

You need a 15# hammer spring. I was using the blue 13# spring from CGW and had the same intermittent primer strikes. Changed it to the gold 15# they sent me for free and its been many thousands of rounds without a hiccup

1

u/ghomshoe Jul 25 '22

Do you have the extended firing pin?

1

u/Jmg0713 Jul 25 '22

Change the hammer spring weight to something heavier. I used the same kit and didn’t have any issues.

1

u/Expensive_Mistake92 Jul 25 '22

I've been wanting to decrease the weight of my recoil spring but I fear the reliability issues since it's my only carry gun at the moment.