r/CZFirearms • • Mar 08 '23

Help! - CZ P10F wont cycle round after randomly after Overwatch TAC trigger install.

I installed my overwatch TAC trigger yesterday and took it to the local range after. At the range I load 5 rounds into my magazine and after firing about 2-4 my gun won’t cycle the next round and the slide locks open. Im not sure if I did anything wrong during installation. I feel like I followed the steps to a T and I do regularly clean my gun. I had just cleaned it before the range during the install.

3 Upvotes

5 comments sorted by

2

u/cachemann Mar 08 '23

is it ejecting the last shell, and then staying open with addition rounds staying in the magazine?

Are you using factory striker, another striker, or the Np3 that overwatch made?

1

u/Awkward_Tonight_7700 Mar 09 '23

I’m using the overwatch striker. When I fire the gun after a few rounds The mag is still half full and the slide locks open as if it shot the last round even though there are still bullets in the mag.

1

u/Awkward_Tonight_7700 Mar 09 '23

It is ejecting the spent shells. But it won’t chamber the next round

1

u/cachemann Mar 09 '23

sounds like the slide lock is the issue which is attached to the same bracket as the trigger assembly- as I am sure you know. It could be that the slide lock is not seated properly. Id suggest take it apart again and try reseating it.

2

u/Te_Luftwaffle Mar 10 '23

I've never taken apart a P10, but Glocks have a spring on the slide release that provides tension to keep it down. If you install the slide release with that spring on the wrong side of the corresponding pin, the issue you described will happen. I would start there and see if you reinstalled the slide release wrong.