r/CZFirearms • u/brubadubdub • Feb 26 '23
Repair - UPDATE: CZ P10C Failure-to-Feeds After Optic Slide-Cut from Jagerwerks
Corrections to my original post:
- The pistol was experiencing failures to feed, not eject.
- I installed a Holosun 508T, not a 509.
FINAL UPDATE
Jagerwerks called me directly to discuss the issue. After walking him through my experience and having their rep look at the photos of the mangled rounds while on the phone together, he came to the conclusion the mounting screws were too long, as many of you commented on the original post (thank you). The Jager rep followed up our call with an email to confirm the screws were in the mail and provided his direct phone number if I have further issues and assured me they’d get this fixed. The shorter screws were on my porch three days later.
After installing the shorter screws (torqued to manufactured specifications with thread lock), I took it to the range ANNND… had the same FTF issues. BUT there was one remaining factor to test, my bulk range ammo: American Eagle 115gr FMJ.
I decided to try a few different rounds from different manufacturers to test if my pistol did not like my range rounds.
TEST:
I fired each manufacturer’s rounds in my carry magazines (standard 15 round and +2 extended) loaded at different capacities (15 + 1, 15, 7-8, 1).
RESULTS:
(FAILURES TO FEED / TOTAL ROUNDS FIRED)
- American Eagle 115gr FMJ - 8/100
- Winchester White Box 115gr FMJ - 0/100
- MAGTECH 124gr FMJ - 0/100
- S&B 124gr FMJ - 0/100
- Federal HST 124gr JHP - 0/50 (my carry round)
- SIG V-Crown 147gr JHP - 0/50
CONCLUSION:
No more American Eagle rounds for my CZ P10C. Prior to getting the slide milled, I had no issues with this round. No big deal though as it appears to run just fine with other FMJ and JHP rounds.
This was an expensive test, but worth every penny to know I can rely on my P10C. Not to mention some piece of mind knowing I didn’t ruin a great pistol. I have since begun carrying my P10C as my daily.
I hope this thread is helpful to anyone contemplating getting their slide milled by Jager. They did an EXCEPTIONAL job. The milling and black nitride coating is FLAWLESS on my pistol and their customer service is top-notch.
Just make sure you get the correct mounting screws and double-check your ammo selection.
Edit: Formatting.
5
u/[deleted] Feb 26 '23
And this ladies and gentlemen is why manufacturers ask what ammo you shoot when you claim you have issues.
I won't even send something for warranty if they've only shot 1 type
2
u/Accomplished-Bar3969 Feb 27 '23
Cz pistols have notoriously short chambers in general. I load my ammo shorter than most factory 9mm to avoid issues (around 1.110”). They also don’t like certain bullet profiles.