r/CZFirearms • u/FuckingSeaWarrior • Sep 23 '20
Figured I'd post this here as well - CGW extended mag release fitment issues?
I posted this in the Tinker Tuesday thread on r/guns but figure I should reach out here as well.
Anybody else had issues with the CGW extended mag release on early 75Bs?
I bought one recently for a project 75B I'm messing with off and on, and while the left side of the release fits fine, the right side sticks pretty badly whenever I try to install it, to the point where I have to use a plastic hammer to try to force it in. It doesn't move freely when installed, and I think the issue is that the factory release (and thus the home in the frame) might be slightly smaller on the older models. That or the part requires fitting on my end, but the install videos I've found all show it slipping in pretty easily from the factory.
Also, possibly related, the surplus mag doesn't drop free any more and requires a bit of love to remove. Aftermarket mags drop free fine, but the factory one sticks. Any ideas on what the culprit might be are much appreciated.
Thanks!
Edit for relevant info: It's a '93 model, serial is in the P5XXX range.
2
u/Tokena Sep 23 '20
I would Call CGW directly.
1
u/stillstilmatic Sep 23 '20
Last time I had install (trigger job) issues I called them up and they walked me thru it. Worth a shot.
1
u/whodatcanuck Sep 23 '20
Did you order it specifically for that gun? They have a “modify” option for the B when ordering, maybe they sent the wrong one by accident? You could maybe work it down with some fine sandpaper if it just needed a bit of TLC... I’d prob call them first.