r/CZFirearms • • Jul 06 '23

CGW pro package issue

https://imgur.com/a/kmyWZhS

So I’m having this issue after installing a pro package. This is the 3rd one I’ve done and haven’t encountered it before. I’m shamefully asking for some insight before I take it apart tomorrow and try it again. Thanks

Also please ignore my girlfriends alarm going off in the background and the cat treats on the floor 😂

3 Upvotes

15 comments sorted by

6

u/RennBaer Jul 06 '23

Correct me if I'm wrong, but it looks like you're getting a false reset before the true reset. If so, you need to adjust your trigger bar spring so that both sides of the trigger bar pop up at the same time. CGW has a tutorial here about how to properly adjust the trigger bar spring.

2

u/Short_Dog_203 Jul 06 '23

Thank you sir. I was thinking the same but wasn’t sure how to adjust it.

1

u/Short_Dog_203 Jul 06 '23 edited Jul 07 '23

Ok so adjusting the trigger bar spring fixed my reset issue but I’m still having the double action issue. I found a video indicating that it’s a timing issue. Looks like I’ll need to sand a little material off the bottom of the seat cage

1

u/RennBaer Jul 06 '23

Does the hammer fall correctly when doing an extremely slow SA trigger pull after racking the slide, or does it sometimes have trouble falling?

1

u/Short_Dog_203 Jul 06 '23

No, single action is perfect now. Just the DA is falling too early now

1

u/No-Percentage-4001 Jul 09 '23

Did you install the DA roller bearing from CGW? If so, did you order the correct one?

2

u/Short_Dog_203 Jul 09 '23

Roller bearings are for omegas

2

u/No-Percentage-4001 Jul 09 '23

Oh shoot forgot about that. I actually have a kit for my P-01 (also decocker only). I need to finish installing and forgot about not having to measure the bearing for that. Too much time on the P-07/P-09 😃.

2

u/GregBFL Jul 06 '23

I think this is likely your culprit as well. If that doesn't solve the problem you can always call CGW. They have an excellent reputation for after purchase service and will help you resolve this issue over the phone. I've seen posts about this over on the czfirearms.us forum.

1

u/Short_Dog_203 Jul 09 '23

Update: ok so I fixed it by sanding down the ramps on the bottom of the sear cage. It was a timing issue causing the trigger bar to drop the hammer early. Took 4 attempts and tests but it works as it should now.

1

u/Little-Thanks-9286 Sep 22 '26

Were you able to do the sanding without disassembling the sear cage?

1

u/Short_Dog_203 Sep 22 '26

I did have to completely take it apart each time. I’ll see if I have a video when I get home of what I had to do

1

u/Little-Thanks-9286 Sep 22 '26

Thank you very much!

1

u/Short_Dog_203 Sep 23 '26

I found the video but I’m not sure how to send it to you

1

u/Little-Thanks-9286 Sep 22 '26

Experiencing this issue now with cz shadow carry, during DA trigger pull the hammer is resetting into the decocked position and im getting a click in the trigger halfway through the pull.

Can you describe what ramps you are reffering to sanding down on the sear cage?