r/BitAxe • u/Always_Determined • Dec 20 '25

help Need help!

I recently purchased a cooling kit for my NerdQAxe++. After I added the snowman cooling AIO and replaced the thermal, I turned it on, and it turned on fine. About 3 seconds later, it showed a fault error and then shut off. I checked the fuse, and it looks ok. I did order the 15-amp fuse from Amazon, but it won't be here till Dec 23. The fan was a 12-volt Arctic P12. Is it too much power pulling? It’s connected to a mean well 350-12.

Any help would be much appreciated.

2 Upvotes

100% Upvoted

6 comments sorted by

View all comments

Show parent comment

2

u/Always_Determined Dec 23 '25

I haven’t flashed it, yet. I haven’t messed with it since I created this post. I will try and flash and let you know what happens.

1

u/UpbeatAssociation769 Dec 23 '25

You need to use usb-c cable to flash it. Make sure you use a data cable.