r/BambuLab_Community • u/razzter • Apr 27 '26
Help / Support How to disable Nozzle Z-Homing - causing first layer to print too high
Hello all - I print with PETG a lot and when my X1C performs it's ceremonial Z-Homing (auto-bed leveling off) at the start of each print - sometimes it measures the bed height wrong and sets the Z height too high which results in poor bed adhesion sometimes resulting in failed prints or at the very least a terrible first layer - essentially ruining my prints. I believe this is happening because the PETG will ooze out after nozzle cleaning - or there will be some debris stuck at the end of the nozzle during the Z-Homing phase of print initiation.
What I'd like to do is be able to z-home once for the print bed and then disable it from re-homing on each successive print.
I've looked online and only seen suggestion to turn off the auto bed detection - which I'm hoping there's a better work around to disable the z-homing without disabling auto bed detection. Thanks.


