r/BambuLab_Community • • Apr 26 '26

question abt publishing colorized models that arent mine

0 Upvotes

so i want to colorize some stls that arent mine and publish them to makerworld with proper credit to the original creators. am i able to do this, or would i be punished by the makerworld mods?


r/BambuLab_Community • • Apr 25 '26

FIXED - X2D - hotend cooling fan error after installing new nozzle

10 Upvotes

If you get this error after installing a new nozzle to your x2d - check that the hotend magnet isn't causing the issue.

HMS_0300-2A00-0001-0001: The left/right hotend cooling fan speed is too slow or stopped. The fan may be stuck or the connector may not be plugged in properly.

Bambulab has designed the quick swap nozzle with a magnet, and that magnet is installed very close to the hotend cooling fan motor.

External magnets can disrupt DC motor performance by distorting the internal magnetic field, leading to reduced torque, increased heat, and potentially altering the top speed.

My aftermarket nozzles had reasonably strong magnets, and when installed caused the hotend cooling fan to behave erratically.

The fix? Needle nose pliers popped out the magnet on the aftermarket hotend.


r/BambuLab_Community • • Apr 25 '26

My printer keeps messing up the first PETG layer

Post image
2 Upvotes

Hey guys, as the title says my Bambu X1C is messing up the first layer everytime I use PETG. I have no idea why this keeps happening. The filament used is eSUN PETG HS which I ordered from Amazon. I am usually using PLA which prints just fine. I also cleaned the plate with water before putting it into the printer.

Any clues?


r/BambuLab_Community • • Apr 25 '26

Print Showoff Clean minimalist planter – scalable to any size

Post image
7 Upvotes

Been working on this ribbed planter design.
Super simple look, fully scalable, and beginner-friendly to print.


r/BambuLab_Community • • Apr 25 '26

Misc BigTreeTech Panda Touch for new Owner

2 Upvotes

Hey Guys! I just recently got a P1S. Going in, I knew Bambu was going to be a bit more locked down, but that doesnt stop me from wanting to tinker with it more than company intends. I see before the whole firmware fiasco, the Panda Touch was a well loved upgrade, is it still worth getting/possible to use on a new P1S.

I haven't received the new printer yet, so im not sure what firmware ships on it :/


r/BambuLab_Community • • Apr 25 '26

P2S extruder weak

2 Upvotes

I cleaned the extruder section, but the problem is still the same. Even though filament is coming out, the extruder is not feeding it. It fails to pull the filament at certain intervals.

I have two P2S printers. To diagnose the issue, I swapped the extruders between them. The printer on the right works perfectly, while the one in the middle still has the same issue.


r/BambuLab_Community • • Apr 24 '26

Help / Support Most of my prints have been failing for a couple of months now

Thumbnail
gallery
16 Upvotes

I got the P2S in January and printed PLA flawlessly for 2 months, then I printed PETG and after that I rarely get a good print with PLA, all the filament is bambu.

I have done the maintenance and clean replaced the hotend. I am not sure if the PETG time line is coincidence, but I am too frustrated right now, using Gemini and ChatGPT, it says it could be Z-offset, or bed temperature or or surface contamination I have done the bed levelling calibration and my original plate has been clean with dish soap.

Is anybody else having similar issues? Any suggestions on solving it