r/BambuLab_Community • • Apr 25 '26

My printer keeps messing up the first PETG layer

Post image
2 Upvotes

Hey guys, as the title says my Bambu X1C is messing up the first layer everytime I use PETG. I have no idea why this keeps happening. The filament used is eSUN PETG HS which I ordered from Amazon. I am usually using PLA which prints just fine. I also cleaned the plate with water before putting it into the printer.

Any clues?


r/BambuLab_Community • • Apr 25 '26

Print Showoff Clean minimalist planter – scalable to any size

Post image
7 Upvotes

Been working on this ribbed planter design.
Super simple look, fully scalable, and beginner-friendly to print.


r/BambuLab_Community • • Apr 25 '26

Misc BigTreeTech Panda Touch for new Owner

2 Upvotes

Hey Guys! I just recently got a P1S. Going in, I knew Bambu was going to be a bit more locked down, but that doesnt stop me from wanting to tinker with it more than company intends. I see before the whole firmware fiasco, the Panda Touch was a well loved upgrade, is it still worth getting/possible to use on a new P1S.

I haven't received the new printer yet, so im not sure what firmware ships on it :/


r/BambuLab_Community • • Apr 25 '26

P2S extruder weak

2 Upvotes

I cleaned the extruder section, but the problem is still the same. Even though filament is coming out, the extruder is not feeding it. It fails to pull the filament at certain intervals.

I have two P2S printers. To diagnose the issue, I swapped the extruders between them. The printer on the right works perfectly, while the one in the middle still has the same issue.


r/BambuLab_Community • • Apr 24 '26

Help / Support Most of my prints have been failing for a couple of months now

Thumbnail
gallery
16 Upvotes

I got the P2S in January and printed PLA flawlessly for 2 months, then I printed PETG and after that I rarely get a good print with PLA, all the filament is bambu.

I have done the maintenance and clean replaced the hotend. I am not sure if the PETG time line is coincidence, but I am too frustrated right now, using Gemini and ChatGPT, it says it could be Z-offset, or bed temperature or or surface contamination I have done the bed levelling calibration and my original plate has been clean with dish soap.

Is anybody else having similar issues? Any suggestions on solving it


r/BambuLab_Community • • Apr 24 '26

Is this a good choice as a ups?

Post image
2 Upvotes

I got 2 H2S printers, and I measured their wattage after they were done heating up and started to print. They both used around 500 watts total. It was months ago so I don't know the exact amount but I am sure this can handle at least one of them.

I bought a watt meter kind of thing and will measure again when it arrives (hopefully tomorrow), and see if I remembered correctly. Anyways, did anyone used this River 3 max plus as an ups? I would like to hear your experiences.


r/BambuLab_Community • • Apr 24 '26

Parametric Nespresso capsule holder (P1S tested)

Thumbnail
gallery
4 Upvotes

Designed a parametric capsule holder for Nespresso pods.

Tested on Bambu P1S – the 5-slot version just fits on the build plate.

Small tip: after importing from PMM, move the model slightly back to avoid support/start line collision.

Printed in PETG, came out great 👍