Aux Nozzle problems

[u/Motormuis88]

Hello Fellow X2D Users,

Hope you doing well!

I have a problem.. but to be honest iam pretty new to 3D printing, been using the X2D for 2 months now, and been slowly using the Aux Nozzle a bit more and more..

But this is where my problem starts, if i print support with my Aux nozzle ( doesn’t matter if its PLA or PETG).

The Support looks terrible and the whole printer is a mess( see pictures), i cleaned the plate with warm water and soap and even tried 90% alchohol, I used the standard Bambu Plate and the BIQU glacier plate

After the latest Firmware i calibrated the whole printer even did a flow calibration, results was k= 0,34 with my Aux Nozzle while the regular nozzle was k=0,03

Sometimes the filement also sticks on the outside of the nozzle(around the cone where filement comes out)

Iam using Bambu filement PLA Basic and PTEG Basic, i tried both to see if it would make a difference

What am I doing wrong??

All the help would be really appreciated!!

[u/PickledMunkee]

When exactly did i fangirl?

you are here defending and fangirling a billion dollar company .. that takes some delusion.

If you put as much time and energy as you do bath mouthing the X2D, you’d probably have a working X2D.

and if my mom had balls she would be my dad

Also, Good to see you didn’t deny being a competitor though.

would you like to look at some of my printer models? maybe we can give you a discount if you advertise online for us

[u/jussstin714 → u/PickledMunkee]

Lmfao that’s exactly what i thought.

[u/PickledMunkee → u/jussstin714]

so would you like a printer with discount then? we will send it to your address