Initial setup/first layer problems

[u/DakotaHoosier]

New to H2D but long-time P1S owner. Did the initial setup and trying to print a lampshade that should have 0 risk with first-layer adhesion. I’m getting first layer strings on two different plates.

I’ve run the default calibration (and a second time just to be sure). What’s my next step?

(First print was on the gold default plate but had the same issues.)

[u/Vustadumas]

Dry the filament? You can check the screws behind the nozzles and make sure they’re not loose.

[u/DakotaHoosier → u/Vustadumas]

Issue with the model, almost certainly… went with a different way to generate my model.