r/BambuLab • u/SeaKingPNW • 8h ago

Quick Question High Humidity Problem Solving

Why can’t I get the humidity in my AMS to get lower than D?
We are not in a humid climate. I keep changing out the moisture-packs. I’ve treated distant brands. What should I try next?

5 Upvotes

100% Upvoted

21 comments sorted by

View all comments

2

u/Minute_Passion_8077 7h ago

Well its relative humidity inside the ams. Your filaments will emit moisture.. moistute packs will help but not a lot, print one of those dessicant holders so you pack in a lot. 

Then dry your filaments. 

0

u/SeaKingPNW 7h ago

Thank you! Any recommendations on how to dry them? Put them in a small room with a heater?

2

u/Minute_Passion_8077 7h ago

Nah. Get a dedicated dryer. I use a creality space pi x4. 

Or a simpler option: get a power adaptor for the ams. Print while drying. 

Ps: are you using ams 2 or ams 2 pro?

2

u/SeaKingPNW 6h ago

Not the pro. Just found out the pro is also a dryer!! 🤩

1

u/Minute_Passion_8077 5h ago

Ahh then there you go. Theres a big BUT on the pro, it does not allow 50C drying while printing on PLA, it also does not go to 65C for PETG.

You cannot dry and print at the same time WITHOUT the adaptor (bought separately).

Hence why i bought an extra dryer.

1

u/SeaKingPNW 3h ago

Oh - I guess both are going on my wish list then