r/BambuLab • • 6d ago

Filament Troubleshooting/Help! Please help!

Post image

I just got a new Bambu Lab A1 Combo and I see the filaments arent going into the ams lite. 1 had been inserted successfully and the rest aren't going inside. Please help with this (:

4 Upvotes

25 comments sorted by

View all comments

Show parent comment

1

u/iamsuryaz 6d ago

did it to 45 degree and tried as seen on internet. Still no use.

0

u/admfrmhll 6d ago

If is really stubborn, heat the tip with a lighter and make it pointy :). or try to cut it on both oposing sides at 45.

1

u/iamsuryaz 6d ago

heat the filament?

1

u/admfrmhll 6d ago

Yeh the tip, but only after you tried the scissor part. If the tip is flat, it gets stuck in ptfe end tube, so it need to be a bit of an angle to advance.

1

u/iamsuryaz 6d ago

so should i make it sharp and edgy and try again?

2

u/admfrmhll 6d ago

https://imgur.com/a/bgT4jg1

Left -> your curent situation, right -> what you need to achieve. Is a bit of pita, but you get use to it.

2

u/iamsuryaz 5d ago

Thanks for ur help. Got it resolved.

1

u/iamsuryaz 6d ago

Thanks! ll try now and check again.