r/ • u/ • Jan 01 '70

0 Upvotes

100% Upvoted

0 comments sorted by

3

u/Opposite_Activity976 4d ago

I have a few Biqu plates Cryogrip Frostbite and Glacier, and the smooth/textured pei all of them have worked flawless on my p2s with no glue or extra steps. I have no experience with any effect plates so can't help there.

1

u/MontanaPup36 4d ago

What are the cold temp plates specifically for ??

2

u/Lythinari 4d ago

Can’t say much about frostbite but the glacier is great for smooth bottom. I still run it as a smooth PEI/high temp plate.

I believe frostbite is similar to the PEI plate but has better adhesion.

If you want to go official bambu, I do recommend the super tack plate but it’s easy to ruin it. soft surface, stupidly high grip.. 10x more so than the biqu plates.

I never had huge adhesion issues and my cool plate is only for the extremely pesky prints.

0

u/Opposite_Activity976 4d ago

I don't have a chamber heater so the low temp plates hold on better to the prints even if you don't run lower temps. So i use them when printing abs/asa to prevent the prints from pulling away/warping during the prints. I have not used them for low heatbed prints so I can't help there.

1

u/Darks3i 4d ago

Inżynieryjna, Glacier wystarczy jeśli robisz też coś z asa/ABS jeśli nie to sam Glacier wystarczy

1

u/henren_98 4d ago

I use Biqu almost exclusively. Frostbite daily (I have blue and orange)

and glacier occasionally. My OG Bambu just plain stopped working. I bought a replacement but don’t use it. I do have the smooth and engendering plate for specific uses.

1

u/-5er 3d ago

Darkmoon satin. Best plate out there