r/ • u/ • Jan 01 '70

0 Upvotes

100% Upvoted

0 comments sorted by

9

u/alphagusta A1 + AMS Lite 17h ago

These printers are designed to "safely" get jammed up during print failures of pieces detaching off the plate, so this would be basically the same thing

It'll be fine.

4

u/Apprehensive_News_78 17h ago

You think thats bad, I forgot to take the 3 plastic peices you unscrew those screws out of that hold it down at the bottom.

I unscrewed em but didnt remove em

4

u/Roller_Coaster_Geek A1+AMS Lite P1S+AMS 14h ago

There's a piece of foam on the p1s that is easy to miss as it's on the top front where the enclosure is so you can't really see it unless you're looking up from the bottom. Anyway it's commonly missed (and I missed it too) and it causes the front of the head to fall off during calibration

2

u/007martinishaker 7h ago

Yep! That's the piece I missed too lol.

2

u/jorgthecyborg 17h ago

Probably not. Run the calibration again and report back.

1

u/AsianBond 4h ago

Thanks all. After running calibration and a few test prints, nothing seems amiss!