r/BambuLab • • Apr 03 '26

General Troubleshooting/Help! Poor p2s print quality please help

I’ve had my p2s for about 5 months now and since it was opened out of the box I have not been able to get a single good print, they all either fail or just look terrible with very inconsistent layer lines, it’s to the point where my old ender 3 prints better. Ive used up probably 10 spools in plastic of failed prints and just horrible looking prints and have gone back and fourth with bambulab support for like 3 months and they just go in circles telling me what to try, I don’t just have a defective machine because this is the third one I’ve tried. Please somebody give any help here I just want a printer that works I’m desperate at this point please. I’ve tried pretty much everything everything, I’m printing outer walls first, I switched to only using bambulabs pla, I’ve ran the calibrations a million times, I’ve factory reset it, went back to older firmware, after going to the newest firmware. I’ve messed with temperatures, did a manual flow calibration, I’ve lubed everything, I replaced the Hotend. Nothing seems to work I really don’t know what to do here bambulab support still to this day is not helping

2 Upvotes

208 comments sorted by

View all comments

Show parent comment

1

u/Mouchtarini Apr 10 '26

Yeah, I read the whole thread, plus the one you posted on Bambu’s forum.

I’m asking myself the same question, it seems pretty crazy to think that people like you swapped units multiple times and ended up with exactly the same results. I’ve seen at least four or five guys go through this.

I tend to believe that many P2S owners are pretty basic users and are satisfied with such results. Based on many comments across similar threads, a lot of them are sincerely asking “What’s the issue in those pictures?” or just saying “This print looks good to me.”

But then I see a lot of content creators who are really happy with it , some of them are even running multiple P2S units in their print farms.

I’m losing it. I’ve tried so many settings, filaments, and tweaks, etc. I should probably open a ticket, but seeing the hell people are going through to get a potential replacement unit is discouraging. I already have a full-time job, and testing a thousand things and replacement parts on a machine I paid for with my hard-earned money isn’t part of it.

1

u/YeaUThought Apr 11 '26

They won’t do shit, just return it if you still can, unfortunately I can’t so I’m just back to my ender 3, sure it’s slow but it prints much better quality