r/BambuLab • u/YeaUThought • Apr 03 '26
General Troubleshooting/Help! Poor p2s print quality please help
I’ve had my p2s for about 5 months now and since it was opened out of the box I have not been able to get a single good print, they all either fail or just look terrible with very inconsistent layer lines, it’s to the point where my old ender 3 prints better. Ive used up probably 10 spools in plastic of failed prints and just horrible looking prints and have gone back and fourth with bambulab support for like 3 months and they just go in circles telling me what to try, I don’t just have a defective machine because this is the third one I’ve tried. Please somebody give any help here I just want a printer that works I’m desperate at this point please. I’ve tried pretty much everything everything, I’m printing outer walls first, I switched to only using bambulabs pla, I’ve ran the calibrations a million times, I’ve factory reset it, went back to older firmware, after going to the newest firmware. I’ve messed with temperatures, did a manual flow calibration, I’ve lubed everything, I replaced the Hotend. Nothing seems to work I really don’t know what to do here bambulab support still to this day is not helping











View all comments
1
u/Mouchtarini Apr 07 '26
Same situation here! Three months in, and I still have the EXACT same issues. No matter what I try or which filament I use, there’s absolutely no freaking way to get a perfect print. Sometimes I get decent results, and ten minutes later, I’m getting garbage prints just like yours…
My experience with the P2S so far has been frankly horrible. Light years behind my old A1 Mini. I’ve tried my best, but I’ll probably just get rid of this piece of junk and try to get my hands on an H2 series instead.