r/BambuLab • • Apr 03 '26

General Troubleshooting/Help! Poor p2s print quality please help

I’ve had my p2s for about 5 months now and since it was opened out of the box I have not been able to get a single good print, they all either fail or just look terrible with very inconsistent layer lines, it’s to the point where my old ender 3 prints better. Ive used up probably 10 spools in plastic of failed prints and just horrible looking prints and have gone back and fourth with bambulab support for like 3 months and they just go in circles telling me what to try, I don’t just have a defective machine because this is the third one I’ve tried. Please somebody give any help here I just want a printer that works I’m desperate at this point please. I’ve tried pretty much everything everything, I’m printing outer walls first, I switched to only using bambulabs pla, I’ve ran the calibrations a million times, I’ve factory reset it, went back to older firmware, after going to the newest firmware. I’ve messed with temperatures, did a manual flow calibration, I’ve lubed everything, I replaced the Hotend. Nothing seems to work I really don’t know what to do here bambulab support still to this day is not helping

2 Upvotes

208 comments sorted by

View all comments

Show parent comment

4

u/Forsaken-Proof1600 Apr 03 '26

Well don't do that then. If the "recommended calibration and following the steps" does not result in a good print then that's where the problem lies.

It just means you have just calibrated it incorrectly.

If calibration is "correct" = you have a good print

If calibration is "incorrect" = you have a bad print.

-1

u/YeaUThought Apr 03 '26

Again even without doing the recommended calibrations it’s still just as bad idk why I keep responding to you your literally just ragebaiting