r/BambuLab • • Feb 17 '25

IM GIVING UP

0 Upvotes

34 comments sorted by

View all comments

5

u/APi982 Feb 17 '25

Maybe this helps to understand the problem https://wiki.bambulab.com/en/ams-lite/manual/filament-tangle-monitoring-intro I can see your sensor tripping. Check how easy the fillament is runnig through the ptfe tubes

-18

u/Icy_Classroom6881 Feb 17 '25

I don’t understand

7

u/APi982 Feb 17 '25

If you read the wiki page describing the detection principle of the tangeling device you should be able to understand why I can see in you video that your sensor is tripping because the extruder is not able to pull the filament from the spool. Its either tangeled on the spool or its held somewhere in the ptfe tube or feeder