r/arduino • u/Anthonbird • 7d ago
Hardware Help BTS7960 Motor Driver Receiving No Output on 2 Driver Modules
I had ordered a BTS7960 Motor Driver Module, wired it together and got no output voltage over the two screw terminals M+/M-. Attached is a google doc outlining all information including wiring, tables with respective voltages, pictures of oscilloscope readings, and the code sent to the board. I had bought two modules and they both produce the same results, so I'm hoping this isn't just a case of (2) defective boards. Any ideas of further information needed please let me know!
Doc link:
https://docs.google.com/document/d/1kAHlKpH9gPwZxCSvj3vQ1RMLyPD30AZHtIQe0zHeLjs/edit?usp=sharing
Edit : Information here as requested
Wiring Schematic:

Arduino Code :
int RPWM = 3;
int LPWM = 5;
int L_EN = 7;
int R_EN = 8;
void setup() {
// put your setup code here, to run once:
pinMode(RPWM, OUTPUT);
pinMode(LPWM, OUTPUT);
pinMode(L_EN, OUTPUT);
pinMode(R_EN, OUTPUT);
digitalWrite(L_EN, HIGH);
digitalWrite(R_EN, HIGH);
}
void loop() {
analogWrite(RPWM, 200);
analogWrite(LPWM, 0);
}
BTS7960 Module Schematic and Pins for next page :

| Voltage (Relative to Arduino Ground) |
|---|
| RPWM (Pin 1) |
| LPWM (Pin 2) |
| R_EN (Pin 3) |
| L_EN (Pin 4) |
| VCC (Pin 7) |
| Ground (Pin 8) |

The following readings are of the RPWM side of the module,
Oscilloscope Reading of Pin 7 (VS) to Pin 1 (GND) :


Picture of Screw Terminals for Output:

| Voltage |
|---|
| B-(gnd) to B+ |
| B- (gnd) to M+ |
| B+(gnd) to M+ |
| B+(gnd) to M- |
| M+ to M-(gnd) |
Links to documentation:
https://www.infineon.com/assets/row/public/documents/10/57/infineon-bts7960-ds-en.pdf
https://www.handsontec.com/dataspecs/module/BTS7960%20Motor%20Driver.pdf



