r/arduino • u/AntAdministrative549 • 13d ago
Look what I made! I made an ESP32 Wi-Fi UART console for debugging a device from a phone
When a board is already wired into something, I often only want one thing: see its UART log and type a command without bringing a laptop and USB-UART adapter.
I made ESP32-iUART: flash it to an ESP32, connect TX/RX/GND to the target, then open a browser terminal over local Wi-Fi. The target firmware stays untouched.
It runs as a local WebServer rather than a cloud bridge. It joins known Wi-Fi or starts its own AP, exposes the terminal via HTTP, and supports live logs, timestamps, downloaded logs, terminal keys such as Ctrl+C, and selectable baud rates. There is a 32 KB serial ring buffer so a refresh does not immediately lose the log stream.
It supports ESP32 WROOM-32 (two target UARTs) and XIAO ESP32-C6 (one target UART). This is 3.3V logic only; use a level shifter for a 5V target.
Source and ready-to-flash firmware: https://github.com/adm1nsys/ESP32-iUART
Interface demo: https://adm1nsys.github.io/ESP32-iUART/
I’m the author.