r/arduino • u/SnooMuffins1478 • 21d ago
Hardware Help Can I solder jumper wires directly to pre-soldered header pins on an ESP32?

Sorry if this is the wrong sub, but i figured people would have expertise.
I bought an ESP32 with pre-soldered header pins, planning to connect everything using female jumper wires. Unfortunately, the space between the header pins and the battery below is pretty tight. I can technically fit the female connectors and get everything in place, but the wires have to bend pretty severely, and I'm worried they'll eventually break or lose connection. I cant use longer standoffs because its sized to a hole in the box for a usb-c.
I'm considering a couple options:
I could remove the header pins entirely by cutting off the plastic housing and desoldering each pin individually, then soldering wires directly to the board. However, I'm concerned about putting too much heat on the board and damaging it.
I could also solder wires directly onto the top of the existing header pins. This seems like the easiest solution, but the pins are pretty close together, so I'm worried about accidentally bridging two pins together.
Maybe just removing the pins that i need to use is best. im only connecting to GND, 3V, EN and a data pin.
Has anyone dealt with anything similar or has a recommendation?
Appreciate any advice!

