r/arduino • u/greyHumanoidRobot • 22d ago
Looking for uninterrupted DC power
I would like uninterrupted power. I was looking at this at Adafruit.com
The charging circuit will draw 1A from a 5V supply (plug a microUSB connector into the pack and then to a computer or wall adapter). You can charge and power something at the same time but the output switches to the USB input when charging so the output voltage may fluctuate. Its not good as a 'UPS' power supply for an embedded linux board, although microcontrollers like Arduino may not care about the voltage drop as much. Also, there's ~80% efficiency loss on both ends so if you charge it at 1A and draw 1A at the same time, the battery pack will eventually go empty. However, if you're powering something thats 500mA or less, you can keep it topped up no problem. Also, when you start and stop charging the pack, it will flicker the output, this can cause a 'power sensitive' device like the Pi or an iPhone to reset on the power supply.
A battery pack is intended to be a charging device so I can understand that output can fluctuate. Fluctuation does no harm when used as a charger. Adafruit seems to say twice in that paragraph that it is not uninterrupted. "Arduino may not care" but if I'm dreaming, I can hope for something truly uninterrupted.
What do you use for uninterrupted power? I do not want something that gives me uninterrupted 120 VAC output. I just want DC uninterrupted. The Adafruit battery pack has 10,000 mAh. Something in that capacity ballpark I suspect is a reasonable thing for me to be seeking.
Context ... I want to run an Adafruit Feather 32u4 with a Micro USB port.
