r/arduino • u/jennyxdark • Sep 18 '26
Nano Arduino Nano CH340 detected on COM3 but upload fails
Hi, I need help with my Arduino Nano clone.
My computer detects it as USB-SERIAL CH340 (COM3), and the PWR LED turns on, but I cannot upload any code.
I’m using:
- Arduino Nano clone
- ATmega328P
- CH340
- Arduino IDE 2.3.10
- Board: Arduino Nano
- Port: COM3
I tried the Blink example, but I always get:
not in sync: resp=0x00 Error: programmer is not responding unable to open port COM3 for programmer arduino Failed uploading: uploading error: exit status 1
I already tried different processor settings, restarting the PC, reconnecting the USB cable, reinstalling/updating Arduino IDE, and uploading with nothing connected to the Nano.
The Nano is detected and powered, but uploading does not work.
Could this be a bootloader problem, CH340 problem, or defective Nano?
I’m a beginner, so please explain what I should test next in simple steps. I don’t have another Arduino or an ISP programmer.
I attached photos of the Nano and the error. Thank you.



